Cervical spine alignment following lumbar pedicle subtraction osteotomy for sagittal imbalance

Ibrahim Obeid, Anthony Boniello, Louis Boissiere, Anouar Bourghli, Vincent Pointillart, Olivier Gille, Virginie Lafage, Jean-Marc Vital

June 2015, Volume 24, Issue 6, pp 1191 - 1198 Original Article Read Full Article

First Online: 09 January 2015

Purpose

The alignment of the cervical spine is of primary importance to maintain horizontal gaze and contributes to the functional outcome of patients. Cervical spine alignment after correction of major sagittal imbalance has rarely been reported in the literature.

Methods

Retrospective review of 31 consecutive patients with sagittal plane deformities operated by lumbar pedicle subtraction osteotomy. Pre-operative and 3 months post-operative full-length radiographies were analyzed for spinopelvic and cervical-specific parameters.

Results

There was a significant increase in lumbar lordosis (LL), thoracic kyphosis, and sacral slope. There was also a significant decrease in pelvic tilt, pelvic incidence minus LL, knee flexion and sagittal vertical axis. The cervical analysis revealed that there was no significant difference between pre- and post-operative global cervical lordosis (CL) angle and external auditory meatus (EAM) tilt. There was a significant decrease of C7 slope and distal CL, while a significant increase in occipito-C2 (OC2) angle was observed.

Conclusion

LL restoration decreased the need of compensation at the pelvis and thoracic spine. The distal CL and C7 slope decreased because there was no need for compensation at this level after the surgery, but the proximal cervical spine takes a slightly flexed position to maintain horizontal sight. EAM tilt measures the head position toward C7, and is close to 0° even in severe cases. Changes of this parameter after surgery are insignificant, probably due to the balance between upper and lower cervical segments; when one of these segments shifts backward the other shifts forward and the result is a balanced head over C7.

Read Full Article