Serkan Simsek, Kazim Yigitkanli, Hakan Seçkin, Ayhan Comert, Halil I. Acar, Deniz Belen, Ibrahim Tekdemir, Alaittin Elhan


September 2009, Volume 18, Issue 9, pp 1321 - 1325 Original Article Read Full Article 10.1007/s00586-009-1105-7

First Online: 31 July 2009

Although various posterior insertion angles for screw insertion have been proposed for C1 lateral mass, substantial conclusions have not been reached regarding ideal angles and average length of the screw yet. We aimed to re-consider the morphometry and the ideal trajections of the C1 screw. Morphometric analysis was performed on 40 Turkish dried atlas vertebrae obtained from the Department of Anatomy at the Medical School of Ankara University. The quantitative anatomy of the screw entry zone, trajectories, and the ideal lengths of the screws were calculated to evaluate the feasibility of posterior screw fixation of the lateral mass of the atlas. The entry point into the lateral mass of the atlas is the intersection of the posterior arch and the C1 lateral mass. The optimum medial angle is 13.5 ± 1.9° and maximal angle of medialization is 29.4 ± 3.0°. The ideal cephalic angle is 15.2 ± 2.6°, and the maximum cephalic angle is 29.6 ± 2.6°. The optimum screw length was found to be 19.59 ± 2.20 mm. With more than 30° of medial trajections and cephalic trajections the screw penetrates into the spinal canal and atlantooccipital joint, respectively. Strikingly, in 52% of our specimens, the height of the inferior articular process was under 3.5 mm, and in 70% was under 4 mm, which increases the importance of the preparation of the screw entry site. For accommodation of screws of 3.5-mm in diameter, the starting point should be taken as the insertion of the posterior arch at the superior end of the inferior articular process with a cephalic trajection. This study may aid many surgeons in their attempts to place C1 lateral mass screws.


Read Full Article